Electrical power UNITS FOR LIFT TABLE 1
General Description
This power unit is developed solely for that compact lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit has been widely used while in the marketplace of logistic units including minifork lift, scissors lift and ariel working platforms. The lower-ing movement is controlled by the solenoid valve with the pace managed through the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Basic Description
This power unit is made solely for the medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve as well as the velocity controlled by the adjustable needle valve. When the lift rises to a higher positoin, however the power provide is lower, the reducing motion is controlled by the guide override function.
Energy UNITS FOR LIFT TABLE 3
General Description
This energy unit is made exclusively to the substantial lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived from the solenoid valve as well as the pace managed by a strain compensated flow manage valve.
Electrical power UNITS FOR LIFT TABLE 4
General Description
This energy unit is created solely for your significant lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve as well as the velocity controlled from the adjustable needle valve. Once the lift rises to a large positoin, but the power provide is cut, the lowering motion is managed through the manual override perform.
Particular Notes
one. This power unit is of S3 duty cycle, which could only function intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean every one of the hydraulic elements concerned in advance of set up of the electrical power unit.
three. Viscosity with the oil shoud be 15~46 cst,which should also be clean and free of charge of impurities.N46 hydraulic oil is advisable.
four. Oil shifting is needed right after the preliminary a hundred operation hrs,afterwards when every single 3000 hours.
5. The power unit proven is created to be mounted vertically.