علب التروس للقواطع الدوارة - استبدال أومني كود RC-200
Replacement of rotary cutter RC Gearboxes details Specifications:
|Torque||21,000 – 28,350 lb.-in.
(2,371 – 3,201 Nm.)
|Ratios||1.21:1, 1:1, 1:1.21, 1:1.46|
|Seal Type||Triple Lip Spring Loaded|
|Bearing Type||Tapered Roller|
|Oil Capacity||174 oz.
Important – Gear boxes are not filled with gear oil in the factory. It must be filled before the tool is put into use The gearbox is filled with an inappropriate amount of gear oil, which will cause damage to the gear box.
Check cotter pins and roll pins (top of the gearbox output shaft and through tail wheel Shaft) are installed safely to ensure that the equipment is placed under safe conditions for cutting tools Service.
Connect the cutter to the tractor’s three-point junction. Do not install the driveline. Raise and lower the cutter to determine the maximum and minimum distance between the tractor PTO shaft and the gearbox input shaft. If the distance is too large, the drivetrain will be too short for proper meshing; This can damage the driveline during operation. If the distance is too small, the drivetrain can hit the bottom during operation, damaging the cutter or tractor. If the drivetrain is too short, please call your bad boy cutter dealer for a longer drivetrain. If the drivetrain is too long, follow the instructions below to shorten the drivetrain.